Instrument Models » Enigma

Connecting your XCOM to your Enigma

XCOM Instructions:

You need to enable the serial interface on the XCOM radio if you are going to set Frequency from the Enigma, using the option XCOM/Enigma cable. You can do this executing the following steps:

1. Switch the unit off by holding the ON button for 3 secs
2. Hold down the DUAL and MODE buttons and press ON
3. The unit should start and show the software version (Note the version)
4. Press the F/CH knob until RHEAD is shown
5. Turn the F/CH knob clockwise and the display should show ON
6. Press the FLIP/FLOP (double arrow) button

Once this is done the serial interface will be enabled and you can set frequency to the XCOM from your Enigma.

Categories for this entry

Last update: 2007-05-14 11:55
Author: Matt

Print this record Print this record
Send to a friend Send to a friend
Show this as PDF file Show this as PDF file
Export as XML-File Export as XML-File

Please rate this entry:

Average rating: 0 from 5 (0 Votes )

completely useless 1 2 3 4 5 most valuable

You cannot comment on this entry